Skickade ett mail till Scala supporten och allt löste sig. Att jag inte tänkte på det först.
Så för att hjälpa andra som eventuellt har samma problem som jag (dvs inte att skriva till supporten först utan att inte kunna fi ihop telefon med Scala). Här är svaret från Scala:
To resolve your connection issue you must reset the devices and create all new pairings.
Please do a soft reset of the phone by deleting the headset from the phone and turning the phone off for at least 15 seconds and taking out the battery, if possible.
Then you must reset the Q2 PRO unit.
1. Perform FULL PAIRING RESET (not Intercom Pairing reset) to all Q2 PRO’s.
2. With the Q2 PRO powered on press and hold the control button until the unit begins to flash red and blue. (Note it will look like it is turning off; keep holding the Control Button in until it comes back on, Red and Blue alternating.)
3. With the LED flashing red and blue, press and hold ONLY the volume up button for 5 seconds until the unit flashes blue (light purple) 4 to 5 times and then flashes red 3 times and turns off.
4. You have now reset your Q2 PRO.
Next you must re-pair any Bluetooth connections previously connected, starting with Q2 PRO to Q2 PRO intercom pairings.
When attempting to pair your Q2 PRO with and additional Q2 PRO you must follow these steps:
1. Make sure that both Q2 PRO’s are powered on.
2. Press and hold the control button and MC button simultaneously until the headset begins flashing red rapidly. Repeat this process on the 2nd Q2 PRO.
3. Both headsets will flash red until they are connected. After they establish a connection each headset will begin flashing blue at approximately the same time.
It is possible to connect up to two headsets to your Q2 PRO. To add a 2nd Q2 PRO to your headset repeat the intercom pairing process from the beginning.
When attempting to pair the Q2 PRO headset with a Bluetooth enabled phone the phone must support the ability to pair to Bluetooth headsets. It is necessary to place the headset into pairing mode before trying to discover it with the phone. To do this you must:
1. Make sure the Q2 PRO is powered on.
2. Press and hold the Mobile button until the headset flashes Red and Blue. . (Note it will look like it is turning off; keep holding the Control Button in until it comes back on, Red and Blue alternating.)
3. Now search for a Bluetooth enabled headset from the Phone system you are pairing the Q2 PRO with.
4. After your device finds the Q2 PRO you will be prompted to enter a passkey. The passkey for the Q2 PRO is (0000).